Single Phase Track Lighting Spring Holder - Silver

Description

Description
The Maytoni TRA002HR-11B is a single-phase track lighting spring holder built from metal with a silver finish, designed to secure lighting fixtures onto single-phase track rails. The built-in spring mechanism applies consistent clamping pressure to hold track heads in position, preventing movement under normal use while still allowing manual repositioning when needed.

Used in residential, retail and office track lighting systems, the holder sits inside the track rail and clips onto the back of compatible track heads. Installation requires sliding the holder into the track channel, positioning it where the fixture is needed, and engaging the spring lock to prevent lateral movement. The compact 37mm height, 45mm length and 32mm width fit standard single-phase track profiles without obstructing adjacent holders or causing fixture overlap.

The silver metal construction resists corrosion in typical indoor environments and the IP20 rating confirms suitability for dry locations away from direct water exposure. The spring mechanism is built into the holder body rather than requiring separate components, which simplifies stock management for multi-fixture installations and reduces the chance of losing small parts during fitting.

Specification

Height
3.7cm

Length
4.5cm

Width
3.2cm

Finish
Silver

Construction
Metal

IP Rating
IP20

Warranty
2 Year Guarantee

Downloads
Product Manual

Frequently Asked
What track systems is this holder compatible with?

The holder is designed for single-phase track rails, which are the most common type in residential and retail installations. It will not fit three-phase or two-circuit track systems. Check your existing track rail profile against the dimensions in the Specification table to confirm compatibility.

Can the holder be repositioned after installation?

Yes. The spring mechanism allows manual repositioning by releasing the clamp pressure, sliding the holder along the track rail to the new position, and re-engaging the lock. This is useful when adjusting fixture spacing or changing room layouts.

Is the holder sold individually or in packs?

This product is sold as a single holder. For multi-fixture installations, order one holder per track head being fitted. The compact dimensions allow multiple holders to be installed on the same track rail without interfering with adjacent fixtures.

What is the IP20 rating suitable for?

IP20 confirms the holder is suitable for dry indoor locations such as living rooms, retail showrooms, offices and corridors. It is not rated for bathrooms, kitchens near sinks, or any outdoor use where moisture or direct water contact could occur.