3-Phase Track Trinity End Cap - White

Description

Description
The Maytoni Trinity end cap is a white plastic component that closes the open end of a 3-phase surface-mounted track lighting system. Measuring 31mm wide by 33mm high, it clips onto the track profile to seal the electrical conductors at unused termination points, preventing accidental contact and keeping dust out of the track interior.

Installed at track ends where no further extension or power feed is needed, the end cap gives a finished appearance to the track run and maintains electrical safety standards. The white plastic construction matches the Trinity track body colour, creating a continuous line when fitted. Installation requires no tools — the cap pushes onto the track end and locks in place with a friction fit.

The Trinity system uses a recessed 3-phase conductor design, meaning the end cap must fit the Trinity profile specifically. It will not fit other manufacturers' track systems or Maytoni's single-phase profiles. Each track run requires one end cap at the terminal point, plus a power feed connector at the live end.

Specification

Height
3.3cm

Length
3.1cm

Width
3.3cm

Finish
White

Construction
Plastic

Warranty
2 Year Guarantee

Downloads
Product Manual

Frequently Asked
Is this compatible with all 3-phase track systems?

No. This end cap fits the Maytoni Trinity 3-phase track profile only. It will not fit other manufacturers' track systems or Maytoni's single-phase profiles due to differences in the conductor recess design and outer dimensions.

How is it fitted?

The end cap pushes onto the open end of the track and locks in place with a friction fit. No tools are required. The cap should be fitted after the track is mounted and before power is connected.

How many end caps are needed per track run?

One end cap is needed at the terminal end of each track run. The opposite end connects to a power feed or track coupler. A typical straight track installation uses one end cap and one power feed connector.