100W LED Driver IP54 - Black

Description

DescriptionWe stock this 100W LED driver as the power supply behind LED strip, modules and other loads up to 100W total draw. It sits in a black powder-coated aluminium case and takes a wide 180-265V AC mains input, converting it to low-voltage DC output. The wide input range copes with the voltage fluctuations common in older buildings and works off a UK supply without any manual switching.

The IP54 rating protects against dust and water splashes, so as well as ceiling voids, wall cavities and under-cabinet runs it can go in damp spots including covered outdoor areas. The aluminium housing doubles as a heat sink along its full length, and the textured black powder coat keeps the unit discreet where it is surface-mounted in exposed industrial or retail schemes.

It is a non-dimmable driver, so it should not be wired to a wall dimmer or a control system that expects a dimming response. Match it to a constant voltage LED load within its 100W rating. The driver runs silently with no audible hum at full load.

Specification

Wattage
100W

IP Rating
IP54

Input Voltage
AC 180-265V 50Hz

Dimmable
No

Material
Aluminium

Finish
Black

Downloads
Product manual

Frequently AskedWhat can I run from this driver?

It powers LED strip, modules and similar loads up to 100W total draw. Keep the combined wattage of your LEDs within the 100W rating.

Can I use it in a damp or covered outdoor area?

Yes. It carries an IP54 rating, which protects against dust and water splashes, so it suits damp locations and covered outdoor areas as well as indoor voids and cabinets.

Will it work on UK mains?

Yes. It accepts a wide 180-265V AC input at 50Hz, which covers the UK supply directly and tolerates the voltage swings found in older buildings.

Is it dimmable?

No. This is a non-dimmable driver, so it should not be paired with a wall dimmer or a control system expecting a dimming response.