Elbe 150cm Bollard Light - Graphite

Description

Description
The Elbe is a 150cm bollard light built from a graphite-finished metal frame with an integrated 20W LED delivering 3000K warm white light. Four vertical glazed bars run the length of the column between a square top cap and a square plinth base, allowing light to escape through the sides while the LED module sits recessed within the top section.

Designed for driveways, garden paths, patios and terraces where taller path lighting is needed, the 150cm height provides light distribution across wider spaces without needing closely-spaced fittings. The IP65 rating protects against dust ingress and water jets from any direction, making the bollard suitable for year-round outdoor installation in exposed locations. The square 11cm x 11cm footprint requires minimal ground area and the graphite metal finish resists corrosion in typical UK weather conditions.

The integrated LED runs on AC 220-240V mains and cannot be replaced, so the entire fitting should be treated as a sealed unit with a projected lifespan of 25,000-30,000 hours depending on usage. The graphite finish sits between black and charcoal grey in tone, pairing with both warm-toned natural stone paving and cooler concrete or slate surfaces. The four-bar glazed design allows light to spread horizontally along paths while the recessed top module prevents direct upward glare.

Specification

Height
150cm

Length
11cm

Width
11cm

Finish
Graphite

Construction
Metal

IP Rating
IP65

Voltage
AC 220-240

Wattage
20

Colour Temperature
3000K

Warranty
3 Year Guarantee

Downloads
Product Manual

Frequently Asked
Can the LED be replaced?

No. The Elbe uses an integrated 20W LED module that cannot be replaced. The entire bollard is designed as a sealed unit with an expected lifespan of 25,000-30,000 hours, which equates to approximately 10-12 years at average outdoor usage levels.

What does IP65 mean for outdoor installation?

IP65 means the bollard is fully protected against dust and can withstand water jets from any direction. This makes it suitable for exposed driveways, coastal gardens and areas where direct rain, hose washing or heavy spray occurs.

How is it powered?

The Elbe runs on AC 220-240V mains supply. Installation requires hard-wiring to an outdoor electrical circuit by a qualified electrician. The bollard does not include a plug and cannot run on low-voltage garden lighting systems.

What spacing is recommended for path lighting?

For a 1-1.5m wide path, bollards at 150cm height are typically spaced 3-4m apart for continuous light coverage. Wider driveways may require closer spacing or staggered placement on alternate sides. The 20W output and 3000K temperature provide ambient path marking rather than high-intensity flood lighting.