Exility Track L-Corner Connector - White

Description

DescriptionWe stock the Exility L-corner connector in white as the part that turns a run of surface-mounted track through a 90 degree corner. It is made from aluminium in a white finish, and it clips into the internal rail on both arms so the two track sections stay joined and keep their electrical continuity around the bend.

This is the piece to reach for when your track needs to follow a wall, wrap around a room, or trace a ceiling line rather than run straight. Because the corner carries the circuit across the join, you can lay out an L-shaped or perimeter run from a single power feed instead of starting a fresh section at every wall.

The connector keeps the same profile as the Exility track itself, so spotlights and pendants fitted to the run pass over the corner without catching. The white aluminium matches the standard white track extrusions for a tidy look against light ceilings. It is not dimmable in itself, since dimming is handled by the fittings and the circuit you put on the track. You fix the track either side, then clip the connector over the rails to lock the corner in place.

Specification

Dimmable
No

Material
Aluminium

Finish
White

Downloads
Product manual

Frequently AskedWhat does this connector do?

It joins two lengths of Exility surface-mounted track at a 90 degree corner, carrying both the mechanical join and the electrical circuit around the bend so you do not need a separate power feed on each section.

Will it match my existing white Exility track?

Yes. It is finished in the same white aluminium as our standard white Exility track extrusions and keeps the same profile depth, so it sits in line with the run and lets fittings pass over the corner.

Is the connector dimmable?

No. The connector itself is not dimmable; it simply passes the circuit through the corner. Any dimming is set by the spotlights or pendants on the track and the dimmer wired to that circuit.

How is it fitted?

You fix the two track sections either side of the corner, then clip the connector into the internal rail on both arms. We would always have the wiring checked by a qualified electrician.