20W LED Driver 350-500mA - White
Original price was: MX$1.565.MX$642Current price is: MX$642. IVA incluido
Envío y entrega
Devoluciones gratuitas durante 30 días
Description
Description
DescriptionWe stock this 20W LED driver as the power supply behind constant current LED loads such as panels, downlights and strip lighting. It takes a wide 100-260V AC mains input and converts it to a regulated 350-500mA output, and it works straight off a UK 230V supply with no voltage selection needed. The housing is white plastic with ribbed cooling fins along the top to shed heat while it runs.
It is made to sit out of sight inside a ceiling void, behind a light panel or within a cabinet where IP20 dry-location protection is enough. Screw terminals at each end take typical lighting cable, and the driver is rated for continuous running at its full 20W load. Match it to an LED load that calls for a constant current supply in the 350-500mA range rather than a constant voltage one.
The output current is set within the 350-500mA range to suit the connected load and holds steady as conditions change. It is not dimmable, so it should not be wired to a wall dimmer or a control system that expects a dimming response. The IP20 rating keeps it to dry indoor locations only.
Specification
Wattage
20 W
IP Rating
IP 20
Voltage
AC 100-260 V
Output Current
350-500 mA
Dimmable
No
Material
Plastic
Finish
White
Downloads
Product manual
Frequently AskedWhat can I run from this driver?
It is a constant current driver rated to 20W, so it suits LED panels, downlights and strip that call for a regulated 350-500mA supply. Check that your LED load needs constant current rather than constant voltage.
Will it work on UK mains?
Yes. It accepts a wide 100-260V AC input, which covers the UK 230V supply directly with no manual voltage switching.
Is it dimmable?
No. This is a non-dimmable driver, so it should not be paired with a wall dimmer or a control system expecting a dimming response.
Where can I install it?
It carries an IP20 rating, so it is for dry indoor locations such as a ceiling void, behind a panel or inside a cabinet. It is not suitable for damp or outdoor positions.
Crea tu conjunto




