30W 24V DC LED Driver - White

Description

DescriptionWe stock this 30W LED driver as the power supply for low-voltage LED lighting. It is a constant-voltage unit that converts 220-240V AC mains to a 24V DC output, sized for LED strip, LED tape and other 24V loads up to 30W total. It sits in a white plastic housing with terminal blocks for the mains input and the low-voltage output.

We use a driver like this wherever the LED load needs mains stepped down to 24V DC, such as inside a ceiling void, behind coving or within furniture where the wiring is concealed and accessible. It wants some ventilation around the housing to shed heat, and it connects to the mains through a fused spur or junction box with the 24V output wired straight to the LED load.

The output holds a steady 24V DC as the load varies up to the 30W maximum, which keeps brightness even and helps avoid voltage drop at the far end of longer runs. It works on 50/60Hz mains, so it suits both UK and European supplies. It is rated IP20 for dry indoor use only, so keep it away from moisture, bathrooms and outdoor spots. The driver is not dimmable; any dimming has to be handled by a separate 24V DC dimmer module between the driver and the LEDs.

Specification

Wattage
30W

Input Voltage
AC 220-240V 50/60Hz

Output Voltage
24V DC

Dimmable
No

IP Rating
IP20

Material
Plastic

Finish
White

Frequently AskedWhat can I run from this driver?

It powers 24V DC LED loads such as LED strip and LED tape up to 30W total. It converts 220-240V AC mains to a constant 24V DC output.

Is it dimmable?

No. This is a fixed-output driver, so any dimming has to come from a separate 24V DC dimmer module wired between the driver and the LED load.

Where can I install it?

Fit it in a dry, ventilated spot such as a ceiling void, behind coving or inside furniture. It is rated IP20 for indoor use only and must be kept away from moisture and outdoor locations.

How does it connect?

It wires to the mains through a fused spur or junction box using the input terminal block, with the 24V DC output wired directly to the LED load.